Thingiverse
Razor support (mario box)
von acarcamo
4
Downloads
1
Likes
0
Makes
A simple razor holder, looking like the Mario box.
It can be printed as in the photos, for it does not need much strength. One additional shell and infill to 30% (gyroid) and it should be good to go.
The razor had some kind of "ergonomic" neck extra wide (20mm) so it works for any razor thinner than that
It can be printed as in the photos, for it does not need much strength. One additional shell and infill to 30% (gyroid) and it should be good to go.
The razor had some kind of "ergonomic" neck extra wide (20mm) so it works for any razor thinner than that
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
