Thingiverse
RC Boat servo holder
by Mothra78
244
Downloads
189
Likes
0
Makes
The rudder servo on my RC Boat used to be glued with double sided tape and came off once.
So I designed a servo holder in Sketchup, printed it and glued it once the servo was in it in the boat with Epoxy.
Tested it this morning it works fine and allows sharp turns.
So I designed a servo holder in Sketchup, printed it and glued it once the servo was in it in the boat with Epoxy.
Tested it this morning it works fine and allows sharp turns.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
