RC Boat

https://youtu.be/d0IpHtbU63A

This is fully functional RC boat that I made from scratch. It was inspired by commercial RC speed boats.

Parts list:
* 3D printed parts from files. I printed them on Zortrax M300 and they were watertight. There are no special recommendations for print settings, just check if you are able to print whole parts. If not try to resize equally or divide. I also printed larger version, the one that you can see on pics
* M4 235mm boat shaft (self sealing)
* M4 30-35 boat screw (you can start with cheap screw, more expensive do not produce significantly higher trust)
* 4x5 metal kardan joint
* 20-30 ESC
* 2205 2300kV motor (I had this one, you can try another one)
* servo 9g (for the start it can be plastic servo, but I recommend metal servo)
* lipo 1300 - 2200 mah, 3-4 S
* transmitter and receiver (2 channel is enough for start)
* hot glue
* sanitary sealant (cheapest silicone is ok)
* zip ties
* some screws

1. Print all parts. Check if print