RC Body Magnet Mount

I wasn't too fond of the idea of gluing or epoxying magnets to the body of my RC so I decided to develop a cleaner, simpler, quicker, less permanent & less destructive way to mount them.

Tips:

1.) PRINT @ 100% INFILL

2.) You will need

(1) 15mm x 2.5mm round rare earth magnets with a 5mm hole (I bought mine on Amazon and they were advertised as 15x3 but were actually 15 x 2.5 go figure)
(1) cup
(1) spacer
(1) M2 x 8 cap or button head screw

for each mount.

3.) Drill a 5/64 or 2mm hole where you want to place a mount

4.) Place a magnet in the cup

(MAKE SURE TO PAY ATTENTION TO POLARITY OF THE SIDE YOU'RE ADDING TOO) otherwise you'll be printing replacement cups!!

5.) Put the M2 x 8 screw through the spacer

6.) Push the screw through your drilled hole

7.) Screw on your magnet

And you're done!

I used two on each side in the front of my Redcat Gen 8 and left the rear body mounts as hook and loop and I love it. The body stays on even in a roll ov