RC Car Ramp

SummaryThis is a Ramp design for RC Cars, I use it for 1/8 to 1/12 scale offroad cars. It turned out very good and cars get a good kick :)I could have been faster and possibly cheaper using just scrap wood, but hey, I might as well use my printer ;)Print SettingsPrinter: Foo Bar Rafts: Doesn't Matter Supports: Yes Resolution: 0.2 Infill: 40% Notes: I printed with scrap ABS, but the Material doesnt really matter. I used more infill than usual to get better strength, seems tough enough.Print parts A to D and the corner once normal and once mirrored. Then print two of each brackets. the top and bottom support pieces help to keep the wood in shape and may not be necessary. You need a big print bed, its designed to fit on a 30x20cm beb, 20x20 is not big enough!Post-PrintingGet some wooden beams in roughly 50x24, I actually ended up with 48x24 which was just 0.50€ per 2m.As for the surface of the ramp, I used some cheap wood sheet which was easy to