RC Car stand foldable

Wanted a foldable car stand, which could also serve as a shock-stand for different cars, shocks, ...

I drive an Xray XB8, XT8 and XT2 ...
but this car-stand will suit ANY 1/8th or 1/10th buggy.
I might need to make it a bit higher to suit Truggies better.

WORK IN PROGRESS !
But allready "very" usable as is.

You will need some long m3-rods as the axles between the top and legs.
You might use an m3-reamer to open up the axle-holes if they are not printed perfectly open or round. A drill-bit will do as well.

Dimentions about 10 cm wide, 9 cm high, 18 cm long.

The shock-holes will suit for 1/8th and 1/10th buggies



***
Will be worked on:
* might make the top a bit wider
* will improve alignment legs
* will improve the support-brackets. They tend to get loose
* will widen the axles-holes as it is a good but tight fit now.
* considering to make the car-stand higher to suit better with 18th truggies.