Thingiverse
RC Car Stand
by TJT2007
429
Downloads
293
Likes
1
Makes
The RC stand has four shocking building holes (accepts 24mm diameter shocks), holes at each of the four corners to add rubber grommets (approx. 21mm in diameter, approx. 4mm of depth) as well as a slot to keep hardware tidy while working your shocks.
The RC stand with the drawer doesn't have the holes to include rubber grommets due to interference with the shock holes but I would still recommend purchasing rubber grommets from your local hardware store (glue them).The sliding rails for the drawer have a clearance of about .5mm to adjust for printer inconsistencies. Supports will be needed, this may effect the quality of the shock/grommet holes so keep that in mind. Post processing should be straight forward. I've added a picture that shows the orientation of how I printed this model, its up to you.
https://www.instagram.com/p/5CwDB0gnPa/
The RC stand with the drawer doesn't have the holes to include rubber grommets due to interference with the shock holes but I would still recommend purchasing rubber grommets from your local hardware store (glue them).The sliding rails for the drawer have a clearance of about .5mm to adjust for printer inconsistencies. Supports will be needed, this may effect the quality of the shock/grommet holes so keep that in mind. Post processing should be straight forward. I've added a picture that shows the orientation of how I printed this model, its up to you.
https://www.instagram.com/p/5CwDB0gnPa/
TJT2007 also publishes on
19 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
