MakerWorld
Organizers
Model downloaden
RC car wall mount
11
Downloads
8
Likes
5
Makes
This model was designed for 100 millimeter wheels. The Plates with the Arrma logo click in the side of the hooks if you want to use the.Print Settings & InformationSettingRecommendationMaterialPLA or PETG (PETG is recommended for durability, especially if you plan on putting it outside in the sun or somewhere warm)InfillGyroid 15% (recommended for strength)SupportRemove support with pliers (Minimal amount of support, only a small ring around the inside of the bottom)Hardware needed:#10 screws x2 per hook
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
