RC EDF Outrigger 2023

Warning
There is a high risk of total loss of the boat/craft.

Disclaimer:
"Wing_Front_V4" is not fully tested. It is supposed to be able to move if the front lifts too much.

Edit 2024-07-28
Added "Front_V4.1" in an attempt to add more material/strength in the front. (Yes, I know that the mesh is not perfect.)

70mm EDF
Mounting holes for 22x79,5mm plus 82,5mm, or 12,7x82,5mm plus 82,5mm.

There is a high risk of water getting inside the hull. Seal/plug unused holes and seal lids carefully. Seal around cables.
Angle the rudder leading edge so that the bottom corner is the most forward one. See image.
Rudder dimension: Length about 42mm, height about 33mm (about 29mm in water).

Sponsons/Riggers:
https://www.thingiverse.com/thing:5991760

M3 tap for M3 screws. 6mm carbon fibre tubes 400mm long.
70mm EDF.

Center of gravity = 190mm from stern (from stern mounting surface).

Test run:
https://youtu.be/beJh0CvRsi8

First test run:
https://ww