RC Hovercraft tricycle

This is a hovercraft project. Instead of one large pillow, I tried to make 3 separate ones, but this turned out to be not the best idea. Still, you need to make 4 pillows, and instead of one impeller, install two, with opposite rotation.
If you want to build this thing, you will have to finalize the project yourself. Or wait for the next iteration.
All parts are printed with PLA plastic with 30% infill. To print some parts, a 3D printer with a table measuring 300x200 millimeters is required.

Assembly video – https://www.youtube.com/watch?v=pP1Xz0hWwwI

List of components:
1x Impeller with regulator – http://ali.pub/4suv7y
3x Engine 2205 with regulator – https://alii.pub/6wpdrh?erid=2SDnjd5hkgY
3x Propeller – https://alii.pub/6wpdvk?erid=2SDnjeLM9VS
1x Servo MG958 – https://alii.pub/6ur2ek
1x Disk for servo – https://alii.pub/6urwxy
1x UBEC – https://alii.pub/6qdit0
4x Connector XT60 - https://alii.pub/6urg49?erid=2SDnjeRzE8G
1x Radiolink at10 radio control equipment – ht