Thingiverse
RC Jet boat pump
von maciej_ratka
1.2k
Downloads
1k
Likes
1
Makes
This Jet Pump was designed as a modification to a old R/C boat I have. with an impeller diameter of 26mm it is quite large for the scale of the boat.
The Intake features Intake strakes to minimize ingestion of pond weeds and was designed around the input shaft in a brass sleeve with a O/D of 5mm.
The nozzle has a turning angle of 50 degrees and uses a 1.5mm ~ 40mm long steel pin as pivot and means of controlling the nozzel
The Intake features Intake strakes to minimize ingestion of pond weeds and was designed around the input shaft in a brass sleeve with a O/D of 5mm.
The nozzle has a turning angle of 50 degrees and uses a 1.5mm ~ 40mm long steel pin as pivot and means of controlling the nozzel
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
