Thingiverse
RC Mount
door Littlenuts
3
Downloads
2
Likes
0
Makes
Mount for various RC components.
Designed to allow either gluing in place or mounting using four countersunk 2mm screws.
Included Sketchup design file. Just alter width and length to fit various different components.
Need supports to print the "hooks". The hooks are likely weak points so might pay to soak in CA to strengthen them, however if only using weak rubber bands, likely not necessary.
The intention is to add a bed of closed cell foam and to only use weak rubber bands so that the component is not "locked" to the frame and subjected to full vibration from the motor, but is "suspended" on a cushion of air, and gently held in place with the rubber bands.
Designed to allow either gluing in place or mounting using four countersunk 2mm screws.
Included Sketchup design file. Just alter width and length to fit various different components.
Need supports to print the "hooks". The hooks are likely weak points so might pay to soak in CA to strengthen them, however if only using weak rubber bands, likely not necessary.
The intention is to add a bed of closed cell foam and to only use weak rubber bands so that the component is not "locked" to the frame and subjected to full vibration from the motor, but is "suspended" on a cushion of air, and gently held in place with the rubber bands.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!