Thingiverse
RC Plane E-flight Clevis for Push rod
por InToSSH
2
Descargas
2
Likes
0
Makes
Simple replacement for the original E-flight clevis for the 1.3mm threaded push rod.
I use it on my Conscendo Evolution, but should be same for other planes too.
I included multiple hole sizes to make it work with your printer, it should snugly thread onto the rod.
Instead of the built-in pin as is on the original, which would probably snap right away if 3D printed, I used just a matching size paper clip which I cut to length and bent on both sides.
If you need the control horn, it's here: https://www.thingiverse.com/thing:6754021
I use it on my Conscendo Evolution, but should be same for other planes too.
I included multiple hole sizes to make it work with your printer, it should snugly thread onto the rod.
Instead of the built-in pin as is on the original, which would probably snap right away if 3D printed, I used just a matching size paper clip which I cut to length and bent on both sides.
If you need the control horn, it's here: https://www.thingiverse.com/thing:6754021
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
