RC Plane Tail Steering Wheel

This is my remix of the RC plane tail steering wheel remixed in Tinkercad from Jkilby's tail wheel. Original credits at the bottom. I replaced the wheel with Qrome's 54mm wheel and tire. I made the wishbone taller to fit the wheel and I replaced the wishbone and rudder guide connections with threaded posts to prevent the wheel from falling off. Lastly I raised the height of the fuselage plate to add clearance for the threaded post.

Assembly:
1. The wheel and tire are two pieces, I printed the wheel from PETG and the tire from TPU.

2. The wishbone connects to the wheel using a screw as the axle. Insert the wheel in between the wishbone and slide a screw through. Tighten it until it squeezes the wishbone just enough to remove excessive play in the wheel, but not too tight to constrict the wheel from freely rotating. I added a 2nd slightly smaller nylon nut which formed new threads tightly enough to prevent the 1st nut from backing off.

3. The fuselage plate is needed for suppor