RC Snow Tracks - No Hardware

RC Snow Tracks for 1/10 scale models.

It should fit any car with a standard 12mm Hex Wheel Mount.

UPDATE - 2026-01-01

- Added Bigger Idle Wheel (To remove a bit of slack on old set of tracks)

UPDATE - 2025-03-30

- Added V2.1 (Front and Rear LONG)
Small modification to the Anti-Rotation Holder to make the sharp corners less prone to breaking.
Front Frames are now 3.2mm longer to remove a little bit of slack.

- Added a Model #2 for the PLA Paddles (Same model as the TPU version, but the clips are for PLA)
They work fine in the snow, but drive very carefully on hard surfaces or you will break a lot of those sharp corners.

UPDATE - 2023-06-14

- Added Single Link. Could be useful if you have problems printing the tracks as a print-in-place mechanism. (Some people got tracks that were all stuck together and would not move). Feel free to print every link separately but you will need cotterpins for every junction. I haven't tested this however... The whole track could end u