RC snowblower

a large single-stage snow-thrower, designed for the Wild Thumper chassis but can be modified for any large RC vehicle.

uses large "paddles" to throw snow over 20 feet ahead of itself, so more than enough for a driveway!

you need:
at least 300mm of hardened 8mm rod, this is used to reinforce the paddle shaft and couple them to whatever motor you use for this.

2x 4x8x3 bearing
2x 8x12x3.5 bearing
2x 8x22x7 bearing (fidget spinner bearings!)
2x 250mm 2020 extrusion (used to pivot the blower up and away from the ground for transport)
a decently torque heavy motor (i suggest a gearbox one, as this takes a lot of torque to get going.
about 1kg of filament, this is quite the big print!