Thingiverse
RC Switch Nut Key
by TheCovidian
11
Downloads
8
Likes
0
Makes
Here is a nut driver for those nuts on the transmitter switches.
The second key has a deeper chamfer in case the first key is not deep enough or you rip the lugs off over-tightening the nuts!
It should be deep enough to accept large switch paddles.
I printed it with .16 resolution but .2 samples don't show any difference. I suspect strength-wise the infill is the determining factor. My original samples were printed with 20% infill and seem to do the job, but if you need something stronger then I suggest more infill.
The second key has a deeper chamfer in case the first key is not deep enough or you rip the lugs off over-tightening the nuts!
It should be deep enough to accept large switch paddles.
I printed it with .16 resolution but .2 samples don't show any difference. I suspect strength-wise the infill is the determining factor. My original samples were printed with 20% infill and seem to do the job, but if you need something stronger then I suggest more infill.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
