Thingiverse
RC Transmission v2
by czPanzer21
32
Downloads
17
Likes
0
Makes
Simple transmission for RC car with generic 12V motor (appr. 27mm diameter).
It´s revised verision without motor cover and output shaft is placed lower.
Speed reduction is 1:8.
For assembly is needed 2mm bearings and pins (for placing gears into positions), 4mm output shaft and 4mm screws with nuts.
I also recommend to lubricate whole mechanism.
Models maybe needs to be scaled x10, because of Blender measurement.
It´s revised verision without motor cover and output shaft is placed lower.
Speed reduction is 1:8.
For assembly is needed 2mm bearings and pins (for placing gears into positions), 4mm output shaft and 4mm screws with nuts.
I also recommend to lubricate whole mechanism.
Models maybe needs to be scaled x10, because of Blender measurement.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
