Thingiverse
RC Transmitter Stand
von Rootech3D
10
Downloads
9
Likes
0
Makes
A stand for holding up an RC transmitter. Fits on the metal bar at the back of your radio, tested on my Taranis.
Use 2mm carbon fibre rods for the cross supports. Glue the rods in the holes of the leg piece.
Use 2mm carbon fibre rods for the cross supports. Glue the rods in the holes of the leg piece.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!