Thingiverse
RC10GT Electric Conversion
door Skidmark01
10
Downloads
13
Likes
0
Makes
This is an electric conversion for an RC10GT using a 540 size motor and 2s LiPo battery. The motor mount and battery are able to be directly screwed to the aluminum chassis using existing screw holes.
I used a "cheap" ESC combo from GOOLRC; 60A ESC with a 3900KV Brushless motor. The battery was a 4600mAh, 50C 2S LiPo and has enough power to spin the slipper clutch and run for about 15 min on a single charge. You'll also need a a couple of 3mm screws for the motor, the original screws to fasten down the 3D parts, and a 32p pinion gear set (16t,17t,18t,19t,20t). I think I finally settled on the 19t one.
Be sure to use ABS for the print because PLA kept compressing around the motor and the screws would loosen up.
I used a "cheap" ESC combo from GOOLRC; 60A ESC with a 3900KV Brushless motor. The battery was a 4600mAh, 50C 2S LiPo and has enough power to spin the slipper clutch and run for about 15 min on a single charge. You'll also need a a couple of 3mm screws for the motor, the original screws to fasten down the 3D parts, and a 32p pinion gear set (16t,17t,18t,19t,20t). I think I finally settled on the 19t one.
Be sure to use ABS for the print because PLA kept compressing around the motor and the screws would loosen up.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
