Thingiverse
RCWL-0516 mounting case
por NZBikerFlyer
15
Descargas
10
Likes
0
Makes
This is just a simple easy to print case for the RCWL-0516 doppler radar motion detector. Case is intended to be mounted behind an existing light switch as an inexpensive (yet awesome) motion detector.
Would be used as part of a larger IOT installation and this case is simply used to contain the electronics board.
Add wires directly or via 2.54 pins and place the RCWL board onto the case pins. use a hot knife or similar to mushroom the pins over to hold the board or use a non conductive epoxy to seal the board into the case.
The case then can be glued or mounted on the inside of an existing switch or wall frame.
Would be used as part of a larger IOT installation and this case is simply used to contain the electronics board.
Add wires directly or via 2.54 pins and place the RCWL board onto the case pins. use a hot knife or similar to mushroom the pins over to hold the board or use a non conductive epoxy to seal the board into the case.
The case then can be glued or mounted on the inside of an existing switch or wall frame.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
