Thingiverse
RCWL-0516
door jxoco
0
Downloads
0
Likes
0
Makes
This case holds a RCWL-0516 microwave sensor and an ESP8266 Node MCU development board and allows the case to be held by the 5v AC adaptor that powers the MCU.
With the micro usb connector.
I don't screw the RCWL-0516 into the case, it fits snuggly and if you are worried that it will touch the back of the ESP8266, just put a little piece of cardboard between the two.
I haven't needed to do that as the tension of the wire keeps the boards away from one another.
It is simple and quick to print and modifiable for multiple projects.
Almost any small screws can hold to lid on, I normally just use something out of my junk box. The design is for 2 x 12mm. The picture shows the range of screws that I have used in this box.
This is a version that hangs from a normal wall plug,
I bought some shorty micro usb cables from amazon to make it neater.
As bought the RCWL-0516 is very sensitive and in a 600 sq ft cabin it picks up when I roll over in my sleep, from the next room. I h
With the micro usb connector.
I don't screw the RCWL-0516 into the case, it fits snuggly and if you are worried that it will touch the back of the ESP8266, just put a little piece of cardboard between the two.
I haven't needed to do that as the tension of the wire keeps the boards away from one another.
It is simple and quick to print and modifiable for multiple projects.
Almost any small screws can hold to lid on, I normally just use something out of my junk box. The design is for 2 x 12mm. The picture shows the range of screws that I have used in this box.
This is a version that hangs from a normal wall plug,
I bought some shorty micro usb cables from amazon to make it neater.
As bought the RCWL-0516 is very sensitive and in a 600 sq ft cabin it picks up when I roll over in my sleep, from the next room. I h
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
