RDB Bolt Release Lever

Bolt release lever for RDB. Mirror objects if wanting to use for left-handed. Use at your own risk. Use higher wall count (not infill) for strength. I'm using M4x12 and M3x12 bolts. If you get this https://a.co/d/0WP3Okh you will have the ones you need - this is what I have. Use your preferred filament - I'm using PLA+ and it's working. So far I've tested it about 20 times and no visible fatiguing of the print.

Checkout my RDB Flared Magwell: https://www.thingiverse.com/thing:6847582
AR Wall Mount: https://www.thingiverse.com/thing:6910987

Update: Updated the lever arm to have a shallower chamfer to seat the arm pin closer to help with side-to-side slop. Updated the ArmPin to have a narrower shank to fit easier into the FlushArm.

Update: Added a new set of arms that allow for using an M4 nut and M4x8 bolt (washer is recommended) to replace the center hinge. Had a scenario where the lever got caught and popped off the arm pin. Allowing for fasteners should prevent/mitigate that issue