Re-Usable Straw Holder

Recently I was asked to make a better storage system for my mom's re-usable straws. She wanted a bigger box, I said why not think vertically! The design is meant for the inside of a cabinet but can be placed anywhere! Included models are a All-In-One Unit which is a little over 300 mm long. Since this is larger than my printer's bed (and most print beds for that matter), I made a split model which uses a simple male and female pin. If printed in the orientation the models are set in, there should be no need for supports besides the male and female pins. *Please note: This model is designed for a wide variety of plastic straws but sizes may vary!If you have any suggestions please leave a comment or post your make!I post about a lot of the models I make and print on my YouTube Channel, Link here: https://youtube.com/@aceganghub