Thingiverse
Re-worked fuel system
2
Descargas
3
Likes
0
Makes
This is a better version of the original with a more simple twin propeller in it.
also there is an air intake so it is more realistic. if you want to have fun tip water down that and it might explode or make the floor a lot wetter
print it at 100% it will only take at 0.3mm about 1 and a half hours
put in comments your thoughts
it has a pulley for rubber bands
for you who did not see the original this is designed to make your RC car more realistic my making a small amount of water come out of your exhaust pipe
there is a fuel tank and filler cap as well so you can use it
there is now an air intake and an exhaust pipe and end for that
also there is an air intake so it is more realistic. if you want to have fun tip water down that and it might explode or make the floor a lot wetter
print it at 100% it will only take at 0.3mm about 1 and a half hours
put in comments your thoughts
it has a pulley for rubber bands
for you who did not see the original this is designed to make your RC car more realistic my making a small amount of water come out of your exhaust pipe
there is a fuel tank and filler cap as well so you can use it
there is now an air intake and an exhaust pipe and end for that
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
