Slicer Discord
Readers Rack – 3D-printbaar model van MakerWorld MakerWorld
Glasses

Readers Rack

door RonRob61 · Glasses
35 Downloads
18 Likes
24 Makes
Model downloaden
Readers, Readers everywhere! I hate the fact that I rely so heavily on my readers. Perfect eyesite except for reading and with that said the glasses are constantly on and off. Pick up the phone, sit at the computer, grab an unfamiliar remote….READERS! I leave them everywhere and have over 30 pairs spread around the house. When I collect them all I had been tossing them on a counter in my kitchen. It was just a mess. The Reader Rack holds 16 pairs but you can stack up a bit and get more on there. At least till I start leaving them all over the place again they now have a home. You'll Need 1 - 3mm x 4mm screw to assemble. You can tighten to make it rigid or just back out the screw a bit to make the top a carousel.
Categorie
Glasses
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

5 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie