MakerWorld
Garden
Model downloaden
Rebar Corner Mount
9
Downloads
14
Likes
2
Makes
I made this simple corner bracket that holds a piece of rebar upright. I attached it to the back corners of my large planter and put chicken wire between them to act as a trellis for my peas. Netting also would have worked. I pushed the rebar all the way to the bottom of the planter and just put one bracket at soil-level. It seems sturdy, but it might not be a bad idea to put one at the bottom as well. I already had stuff planted and didn't want to dig it up, so I didn't bother. We'll see if it matters. This mount attaches with two wood screws. Print Settings Printer Brand: Anycubic Printer: All-metal Mega Rafts: No Supports: No Resolution: 0.3 Infill: 40% Gyroid Filament: Econofil by filaments.ca PLA Black Notes: I used PLA, but PETG or ASA would probably be a better idea if you have some. Category: Outdoor & Garden
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
