Reboot Card Replica

Been working on this design for a little while now and I've finally finished. Very happy with the way it came out . Please review the tips below before printing.Helpful Print Tips:Everything should snap together expect the wires, unfortunately I couldn't figure out a good way to snap them into place so you will need to glue them.Everything should fit together tight so it might require some force to get them into place. If you want to add glue you can but I didn't been too expect for the wires.I printed mine on a Bambu A1. For the center dome I added a modifier in Bambu Studios and positioned it over the "glass" part. I then reduced the infill density to 0.The center dome and the card body (where the bottom pins go) are the only spots that need supports.I did include a full model file (with all the parts together) just in case you want to print one piece.Parts to Buy: This design works with the Bambu Lamp Kit. This model is for personal use only, if you want to sell