Thingiverse
Reborn Hand
353
Descargas
350
Likes
1
Makes
This is a Remix of the Phoenix Hand & UnLimbited Arm, designed by Albert Fung. This project is a collaboration between e-NABLE Sierra Leone and the Hong Kong Maker Club.
It became apparent in our previous feasibility study that for the 3D printed prosthetics to survive the tropics, we need to remove components that are not well-adapted to hot weather. We therefore set out to replace all the rubber bands in the Phoenix hand.
Palm: We used the One-Arm palm designed by below_cho as out starting point. All the cable tunnels have been widened, the knuckle stumps removed, and a bar is added at the thumb base for tying elastic cord.
Palm mesh: we have modified the thick palm mesh by John Diamond to strengthen the screw holes.
Fingers: Tunnels have been created so an elastic cord can now run all the way from the finger tip up into the palm.
Pins: For snug fitting, some of the pins have been resized and reshaped.
Hope you'll find this new remix useful!
Ed Choi
Links:
It became apparent in our previous feasibility study that for the 3D printed prosthetics to survive the tropics, we need to remove components that are not well-adapted to hot weather. We therefore set out to replace all the rubber bands in the Phoenix hand.
Palm: We used the One-Arm palm designed by below_cho as out starting point. All the cable tunnels have been widened, the knuckle stumps removed, and a bar is added at the thumb base for tying elastic cord.
Palm mesh: we have modified the thick palm mesh by John Diamond to strengthen the screw holes.
Fingers: Tunnels have been created so an elastic cord can now run all the way from the finger tip up into the palm.
Pins: For snug fitting, some of the pins have been resized and reshaped.
Hope you'll find this new remix useful!
Ed Choi
Links:
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!