Slicer Discord
Rechargeable Rose – 3D-Druckmodell von Thingiverse Thingiverse

Rechargeable Rose

68 Downloads
72 Likes
0 Makes
Zum Modell
Okay, I love the original, but changing batteries just isn't an easy option. I did see a remix where someone made it far easier to access the batteries to change them, but that still means changing them and paying for new batteries after they run down.

I searched around and found a little board that could be modified to charge rechargeable 2032 batteries and made it all work together. The rose stays lit for over 20 hours on a charge, then just plug it in for a few hours and you're good to go again!
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Ca. Druckzeit
20 h
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen