Thingiverse
Recliner linear actuator
door mrfoyl
0
Downloads
6
Likes
0
Makes
I created this part to repair broken recliner.
This actuator comes in a lot of chairs and sofas and lengths.
it is tested on this exact chair and works fine https://www.jysk.lt/media/documents/lt/assemblyInstruction/129934.pdf
Recommended to print in nylon.
PS this part is meant to break away to not hurt people getting pinched in the chair.
If you print this part with 100% infill and nylon. I am not responsible for any harm that might occur to you.
Please don't use more than 40% infill on this part it might be too strong and break the chair or your bones, instead of the break-away plastic part
This actuator comes in a lot of chairs and sofas and lengths.
it is tested on this exact chair and works fine https://www.jysk.lt/media/documents/lt/assemblyInstruction/129934.pdf
Recommended to print in nylon.
PS this part is meant to break away to not hurt people getting pinched in the chair.
If you print this part with 100% infill and nylon. I am not responsible for any harm that might occur to you.
Please don't use more than 40% infill on this part it might be too strong and break the chair or your bones, instead of the break-away plastic part
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!