Thingiverse
Red Eyes Deck Box
by Printlapse
28
Downloads
16
Likes
0
Makes
A simple Deck Box but as of right now, the 'hinge' doesn't last long but it works perfectly initially.
Instructions:
Print both out and attach the back/lid to the box itself with some sort of glue. To insure it doesn't move while setting, place it on it's back and put some sort of weight in the box (DON'T USE CARDS AS WEIGHTS).
If the hinge fails, a similar colored tape works fine in its place.
The pictures are for the original one I made, it is broken now but it seconds as a screw box.
DISCLAIMER: KEEP YOUR CARDS IN SLEEVES TO AVOID DAMAGING THEM!
There is a Nicol Bolas version of this deck box for you Magic:The Gathering fans that uses this same design that I made. Check it out.
Instructions:
Print both out and attach the back/lid to the box itself with some sort of glue. To insure it doesn't move while setting, place it on it's back and put some sort of weight in the box (DON'T USE CARDS AS WEIGHTS).
If the hinge fails, a similar colored tape works fine in its place.
The pictures are for the original one I made, it is broken now but it seconds as a screw box.
DISCLAIMER: KEEP YOUR CARDS IN SLEEVES TO AVOID DAMAGING THEM!
There is a Nicol Bolas version of this deck box for you Magic:The Gathering fans that uses this same design that I made. Check it out.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
