Thingiverse
Hobby
Ver Modelo
Red Hood Helmet - Small Printer
676
Descargas
554
Likes
4
Makes
This is a remix of Budwin's design to fit the smaller printers that are out there such as the Ender 3 (220 x 220). This was made to print as much in as little pieces as possible (4).
Most of the prints didn't require supports as they were able to lay flat to the build plate. The dome and the face needed supports but only in select places. I put the full size helmet .stl as well so that you can scale to your appropriate size.
The original file is here:
https://www.thingiverse.com/thing:4757926
Most of the prints didn't require supports as they were able to lay flat to the build plate. The dome and the face needed supports but only in select places. I put the full size helmet .stl as well so that you can scale to your appropriate size.
The original file is here:
https://www.thingiverse.com/thing:4757926
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
