Red Rising Razor Prototype

This is a prototype, there are a lot of flaws. In order for this print to work you need to get 1/4" diameter by 2" long springs and a 3mm cord. For the assembly start with the handle, put glue on the mating faces and a small amount on the spring slot. Set the spring into the slot before putting the two halfs together. Repeat this process with the razor segments. Then take the 3mm cord and feed it through the whole thing until it comes out the other side (I recommend taking a drill or file to clean out the internals of the segments before you glue them together). Tie a knot at the end of the cord before assembling the tip.