Thingiverse
Reddit Snoo
door pangolin_workshop
17
Downloads
23
Likes
0
Makes
Snoo two part keychain accessory. Some assembly and adhesive may be needed if you want to combine the two pieces.
If tolerance seem tight, adjust your elephant foot compensation might help.
---
*Update 10.11.18*
* Added three-piece variation so you can mix different colors for the ring, base, and Snoo's face. Just print the peices labeled with ThreePiece and they should fit together.
---
*Update 10.10.18*
* Revised base tolerance for better fit.
---
*Update 10.09.18*
* Added base with no hole.
If tolerance seem tight, adjust your elephant foot compensation might help.
---
*Update 10.11.18*
* Added three-piece variation so you can mix different colors for the ring, base, and Snoo's face. Just print the peices labeled with ThreePiece and they should fit together.
---
*Update 10.10.18*
* Revised base tolerance for better fit.
---
*Update 10.09.18*
* Added base with no hole.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
