Slicer Discord
Reducteur pression douche – Modello 3D stampabile da Thingiverse Thingiverse

Reducteur pression douche

di Tri4L
6 Download
6 Likes
0 Makes
Vai al Modello
FR: Un petit print qui coute quelques centimes et qui fait économiser des milliers de litres d'eau par an. Economies garanties! Compter un gain de 200€ (eau+ gaz/ Elec) par an avec le modèle 3mm.
Commencer avec le modèle le plus petit et vérifier si la pression est acceptable.
Changer pour un modèle avec trou plus grand pour plus de débit si madame gueule par ce qu'elle a du mal à se rincer les cheveux.

Le réducteur se place entre deux joints caoutchoucs, un en dessous et un au dessus.
Il sera impossible de revisser a fond le pommeau mais ça ne pose pas trop de problème.

ENG: A small print that costs a few cents and saves thousands of liters of water per year. Guaranteed savings! Count a saving of 200€ (water + gas / Elec) per year with the 3mm model.
Start with the smallest model and check if the pressure is acceptable.
Change to a model with a larger hole for more flow if ladies has trouble rinsing her hair.

The reducer is placed between two rubber seals, one below and
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione