Thingiverse
Reduction for large diameter spool filament
von Ktar
5
Downloads
5
Likes
0
Makes
The inside diameter of the filament spools is normally approx. 52 mm or large 72 mm.
The two reductions are placed inside the large diameter filament spools to adapt them to the normal supports used usually which are 52 mm.
I personally use this filament spool holder:
https://www.thingiverse.com/thing:4506836
which is only to for coils of small diameter 52 mm.
With these reductions I can also use coils that have a diameter of 72 mm.
The two reductions are placed inside the large diameter filament spools to adapt them to the normal supports used usually which are 52 mm.
I personally use this filament spool holder:
https://www.thingiverse.com/thing:4506836
which is only to for coils of small diameter 52 mm.
With these reductions I can also use coils that have a diameter of 72 mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
