Reinforced Rugged Box

I think the design of 3DMadLab is very successful. However, I tried to make the box even more stable.

I doubled the latches, hinges and changed the thickness of the base to 3mm.
Swapping the screws for threaded rods to ensure more stability.
I stuck a rubber band in the bottom part of the box for waterproofing.
Carbon-Fiber ABS is a good choice as a material.
You can sand the surface of the print and brush it with acetone to get a glossy look.
The acetone also helps with waterproofing as it seals the layers.

I hope you enjoy this remix and let me know in the comments if you like it.