Thingiverse
REJS trash bin height adapter
von ziomcio
0
Downloads
0
Likes
0
Makes
REJS trash bin height adapter needed hence old bin has been damaged and new types are higher (20l volume).
Bin is raised by 45 mm using this adapter.
Fits snugly but I added extra hot glue.
When printing please bear in mind that cutouts are not symmetrical so two pieces need to be printed after a horizontal flip will be applied in the slicer software.
Printing time of 4 adapters with 0.28 resolution and 25% infill took around 10h with the speed of 60mm/s. I have used rafts for better adhesion.
Polish
Adapter do systemu wysuwanych koszów REJS który podnosi 20l kosz wyżej o 45mm przez co da sie go użyć ze starszym systemem wysuwu (podstawa kosza nie zahacza o stelaż).
Bin is raised by 45 mm using this adapter.
Fits snugly but I added extra hot glue.
When printing please bear in mind that cutouts are not symmetrical so two pieces need to be printed after a horizontal flip will be applied in the slicer software.
Printing time of 4 adapters with 0.28 resolution and 25% infill took around 10h with the speed of 60mm/s. I have used rafts for better adhesion.
Polish
Adapter do systemu wysuwanych koszów REJS który podnosi 20l kosz wyżej o 45mm przez co da sie go użyć ze starszym systemem wysuwu (podstawa kosza nie zahacza o stelaż).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!