Reloading Die Holder (Pegboard Compatible)

This die holder is a little beefier than others I've seen on Thingiverse. The shape is a bit more reinforced, and it holds 4 dies per piece (I find myself using 3-4 dies max for a specific cartridge).

I've found that a lot of die holders that incorporate 3D-printed pegboard hooks eventually fail after ~6 months from fatigue when loaded with anything that has some heft to it. This is a new and improved pegboard version, which has slots to accept two standard pegboard hooks from McMaster-Carr (Part #: 18535A113). The end result creates a very strong setup that I'm very satisfied with.

Be sure to print WITHOUT supports. I had difficulty clearing out the internal channels for inserting the pegboard hooks with supports toggled on. These channels are small enough such that the overhang created isn't an issue.