Thingiverse
Remixed_Clamp
door ahmetutkuozkan
30
Downloads
96
Likes
0
Makes
This model is a remix of Clamp Print-in-Place.(https://www.printables.com/model/974751-clamp-print-in-place)
In this version, I've added a rubber section, which is available in three different scale options:
Original scale (1:1)
125% of the original size for all axes
150% of the original size, with the rubber gap adjusted without scaling.
Additionally, I modified the original design by creating a recessed area where I applied a fillet, forming a small groove. The adjustments were made to ensure a better fit and usability for the rubberband.
If you've enjoyed my work and would like to buy me a coffee to support my creative efforts, you can do so through the link below. Your generosity is greatly appreciated!
Buy Me a Coffee: https://www.buymeacoffee.com/ahmetutkuozkan
In this version, I've added a rubber section, which is available in three different scale options:
Original scale (1:1)
125% of the original size for all axes
150% of the original size, with the rubber gap adjusted without scaling.
Additionally, I modified the original design by creating a recessed area where I applied a fillet, forming a small groove. The adjustments were made to ensure a better fit and usability for the rubberband.
If you've enjoyed my work and would like to buy me a coffee to support my creative efforts, you can do so through the link below. Your generosity is greatly appreciated!
Buy Me a Coffee: https://www.buymeacoffee.com/ahmetutkuozkan
ahmetutkuozkan publiceert ook op
21 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
