Remixed Ender 6 Enclosure

This is a remixed enclosure this enclosure is taller specifically 8 inches so that it does not push down on the cables as much, the original creator messed up the dxf files and they were missing a lot of holes. some of the holes were a bit too small for a traditional m3 screw (i think thats what it was supposed to be for) so I just drilled 1/8in hole using the smaller holes as a pilot. I also created a weaker but easier to print and use hinge for the back panel to connect to the top panel. this worked for me using 0.118in cast acrylic (~3mm)