Remote control holder 4 departments

This my remote control holder with 4 departments!You no longer have to look for the remote control all over the living room. Store them at your table in this holder. The print is possible without AMS! The body and side walls are on separarate plates.After printing, simply slide in the walls. No gluing necessary! Print instructions:layer height 0,20mm3 wall loopstop/bottom shells 4 layerstop/bottom shell thickness 0,80mmsparse infill 10%sparse infill pattern “gyroid”Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from Alibaba haven’t good adhesion. Curling will probably occur if you don’t use original build plates! Bad build plate adhesion is not related to the model