Remote Controller case

No supports needed, Print with a brim It is a case for your remote controller. The black remote controller would always blend in with my black couch and I would lose it very often so I made a bright green case and a spot for a lanyard to make it easier to find. Before you print make sure your remote controller is the same as mine based of the image. To put it on Just snap fit it. For me the fit was tight enough to go on without falling out. It is advised that you Decrease the height by scaling it ununiformly in the slicer to see if it fits first, then if it does print the whole thing. If it is too tight or too loose for your linking then just scale the entire thing to how you like it. Keep in mind that even if the short test version is a bit loose the longer version will be stiffer so it might be fine.