Removable transport handle for Microcube

This handle can be quickly and easly clip on the frame of the Microcube, to transport it.

It require some sewing material and competences.

**You'll need:"
- 2 x soft_handle_support.stl
- 2 x r_soft_handle_support.stl (reversed one)
- 2 x 8mm tube 70mm long (you may have scraps of the Microcube structure)
- A 40mm width 40cm long strong tissu for the handle itself. And beld or an old bad strap for example. I use a piece of judo belt (3€ in any sport shop). It must be tick and strong.
- Super glue
- Sewing needle, good strong thread

**Instructions:**
- Print the parts
- Make a handle terminal using a soft_handle_support and a r_soft_handle_support, inserting them in each side of a 8mm tube. Glue them on the tube to be sure it'll never move. Ensure the hooks of each printed part are aligned, and distant by 70mm. The best thing is to clip the item on the Microcube structure, on the rear top tube (in its final position), and wait a few hours for the glue to get strong.
- M