Removeable Silica Container for Drybox

A silica container for drybox that is removeable for maintenance.

4x M3 10mm screws
4x M3 Nuts

Printing advice:
- Prints without any supports.
- Plates flat on the bed
- Holder flat on the bed (with triangle bracings)
- Container 45° rotation, the plane with the ventilation slots on the bed

Mounting advice:
The best way I found to drill the holes is, to start with the two lower holes from the inside of the drybox and drill them through the holder. The pull in both lower nuts with a screw.
After that, put on the exteriour plates and fix them with the two lower screws. Turn the plates on the side and drill the upper holes, then pull in the nuts and fix the plates.