Thingiverse
Removeable spoolholder for ORCA printer
von Chri
6
Downloads
6
Likes
2
Makes
Here are some nice removeable Spoolholders for your great Orca Printer :)
the tip of the lower spoolholer is made a bit longer so you can also put 100mm wide rolls on it , they won`t fall of anymore !
Only for 1,75mm filament !
This is a modification from Mendelparts original spoolholder.
the tip of the lower spoolholer is made a bit longer so you can also put 100mm wide rolls on it , they won`t fall of anymore !
Only for 1,75mm filament !
This is a modification from Mendelparts original spoolholder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
