Thingiverse
Rep 2 stand
door francfalco
40
Downloads
38
Likes
0
Makes
I had to raise my printer up from the desk surface to allow a larger filament spool to fit behind - i did have it standing on some old books, but not a great look!
So, I created this stand.
No support or raft needed.
Print at low res.
The .stl file attached elevates the printer 100mm (approx) from the desk. However, the stand height is easily adjusted in any 3d software.
Print x 4 and you'll need to replace the existing lower corner hex head bolts with 5mm longer thread versions to secure the stands to the printer.
Enjoy!
So, I created this stand.
No support or raft needed.
Print at low res.
The .stl file attached elevates the printer 100mm (approx) from the desk. However, the stand height is easily adjusted in any 3d software.
Print x 4 and you'll need to replace the existing lower corner hex head bolts with 5mm longer thread versions to secure the stands to the printer.
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
