ReP_AL Whoop RC

Micro FPV Drone with camera holder.
This is designed for 6mm brushed motors. The motor holders are slightly oversize to allow for shinkage in the print. On my printer I get a perfect press fit in the holders. If the motors are slightly loose a small piece of tape around the motor, will make the motor tight in the holder.

Frame Weight: 5-6g
6mmx15mm Brushed Motors with connectors 59000RPM (ca. 2g per Motor)
Tiny Whoop 4 blade propellors
Eachine Beecore F3 EVO Brushed ACRO Flight Control Board (ca. 3g)
200maH 1S Lipo 15C (ca. 6.4g)
1 Elastic Band for the 1S LiPo battery
1 Elastic Band for the 1S FPV camera
1S 3.7V FPV all in one camera (choose a 5g camera)

Total Weight 29-30g including FPV camera and battery

Flight Time; 4-5mins with camera, 5-7mins without camera

Assembly Steps:
Setup the Beecore board using Betaflight.
Solder the LiPo connector to the Beecor board
Plug the motors 1-4 into the Beecore Board.
Screw the Beecore Board to the frame using the ca