Replacement cap for insta360 go2 Pivot Stand

The problemThe Pivot Stand for the insta360 go2 is one of the best mounts, but mine broke around the screw where the plastic is really thin.A new pivot stand is cheap, but since the release of the insta360 go3, this one has become impossible to find, so repairing it was my only option The broken piece has the magnets needed to mount the camera, so this print is a shroud around it which allows you to mount the piece back to the rest of the stand with the original screw Required materials3d printed partsandpaperhobby knive to speed things up (optional) Print settingsPla is probably strong enough, but PETG or stronger recommended General settings: print with 0.2mm layers and 100% infill - it will print as all wallsSupports: The holes for the mount + screw intersect, so a bit of one layer will be printed mid air. I have printed this without supports and it still woked because the bridging area is quite small If you enable supports, the hole goes all the way through so you will be able to p